Put Shower Doors Back On

Sliding shower doors commonly fall off.

Put shower doors back on.

Attach the seal strip to the bottom of the door and cut it to the required length. Install the outside panel by lifting it up inside the top track and. Again using the screwdriver loosen the screw holding the roller and adjust it in the slanted slot it is attached to. Tighten the hinges that are attached to the wall.

Replace the shower door and tighten the. Loosen and remove the hinge screws that are attached to the door and remove the whole shower door. Follow the installation instructions provided as details may vary but the following steps are typical. Install the inside panel first.

Learn how to repair these doors and get them back on track with the help of a professional contractor in this free vi. Top rollers adjustment and bottom guide replacement and repair. Make slight adjustments and. Old sterling shower doors from abo.

Attach the door handles and any towel bars. Place the glass clamp sweep into place on the door s bottom edge and secure it at the door clamp. Place end caps on the tops of the wall channels. Spray the hinges with some wd 40 to help loosen them up.

Raise or lower the doors and test the adjustment.