Python Remote Not Locking Doors

This feature can be used in conjunction with power door locks and windows to fully secure the vehicle.

Python remote not locking doors.

Most of our remote starters go into valet mode by pressing a combination of two buttons on the remote control for 1 2 second. Your remote might also have lost programming. Check your connections there. Python remote starter wont start the vehicle doors will not unlock with the remote or start the car but will arm the alarm.

Sometimes after the battery in the car or remote start fob has been changed the fob won t work until it has been reset. The key fob itself could be defective or have a bad unlock button. These should be going to a blue green wire lock and a yellow red wire unlock in the driver side kickpanel. Python s remote start system allows users to operate their power locks and start their vehicle with the simple push of a button.

Even if you forget to arm the system passive arming will protect the vehicle from would be thieves. Try reprogramming your remotes. I used the remote start almost daily without any issue. Try holding the fob right next to the door handle when pressing the unlock button.

In december i had a remote start installed in my truck and am using the original truck key fobs to start the truck. Look on the back of your remote for the proper buttons to press to enter and exit valet mode usually lock trunk. If lock unlock does work please proceed to the next troubleshooting step. If you own one of the high end compustar remotes that have internal batteries then it needs to be charged.

The fob would not lock or unlock the doors. Step 1 sit in the driver s seat and close all of the doors. Its hard to do with it working but you want to try to find the small gauge want to say 16 or 18 blue and green wires coming off the alarm brain. The problems started when i went to use the remote starter afew weeks ago and the alarm went off and i had to shut it off by starting the car with the key.

Try the lock button trunk release button or panic button. If the remote is not responding to you there is a good possibility you just need a battery for it. Make sure that the connecting harness is fully secured. Check the remote antenna inside of your vehicle.

If your remote has usb port plug it into a usb charger and then try again later. When placed in this mode the security system will arm itself 30 seconds after the customer leaves the vehicle. These are your lock and unlock wires blue unlock. Then the daylight running headlights would not work or the keyless entry.

Also the vehicle would not shut off when i took the key out of the ignition had to repeat it to get the car to shut off.